Rondo Rondostar 5000 Basic - Page 139

Troubleshooting
Edition BE210202
03.2022
Rondostar 5000
Operating manual
139
Fault symptom Cause / defect Remedy / repair
5. Conveyor belts loop
through, motor and rollers
turn.
- Belt release
is too weak.
- Drive roller soiled.
- Re-tension conveyor belt evenly (see
2.5.5 Tensioning the conveyor belts:
Belt release [variant] / 2.5.6 Tension-
ing the conveyor belts: Quick-release
belt [variant]).
- Clean the drive roller
(see 6.1.1 Care).
6. Infeed conveyor belt is stationary
or is moving poorly/not at all,
rollers are turning
correctly.
- Electromagnetic clutch
is not working.
- Toothed belt of table drive defective.
- Belt release
is too weak.
- Replace clutch.
- Replace the toothed belt.
- Re-tension conveyor belt
evenly (see 2.5.5 Tensioning the
conveyor belts: Belt release [variant]
/ 2.5.6 Tensioning the conveyor belts:
Quick-release belt [variant]).
7. Outfeed conveyor belt
stationary or jerks.
- Belt release
is too weak.
- Re-tension conveyor belt
evenly (see 2.5.5 Tensioning the
conveyor belts: Belt release [variant]
/ 2.5.6 Tensioning the conveyor belts:
Quick-release belt [variant]).
8. Conveyor belts run off,
are worn at the side.
- Tension of the conveyor belt is
incorrectly adjusted.
- Drive roller soiled.
- Re-tension conveyor belt
(see 2.5.5 Tensioning the conveyor
belts: Belt release [variant] / 2.5.6
Tensioning the conveyor belts:
Quick-release belt [variant]).
- Clean the drive roller
(see 6.1.1 Care).
9. Dough splits open before roller
or passes through between
scraper and infeed belt.
- Scraper:
Check correct mounting.
- Check wear of scraper blades.
- Mount the scraper correctly
(see 6.1.1 Care).
- Replace scraper blades if necessary.
Replace scraper completely if
necessary.