Roth EnergyLogic Touchline/wireless - Page 24

User Manual Roth EnergyLogic Touchline/Wireless
Design and function
24 P100011294 E
Push buttons
Push buttons Description
System Combining several (up to 5) wireless connection modules into
a system.
Master Define a wireless connection module as master in a system
with multiple wireless connection modules. Each system must
have one master. As factory settings, the wireless connection
modules are configured as slaves.
 See also page 56, chapter 7.1.6.
Zone Combining several wireless connection module channels into
a zone or configuring the internal system grid repeater func-
tion. Up to three zones are possible.
Channels
● Address wireless room thermostat and wireless connec-
tion module.
● Delete addressing.
Table 4: Push buttons wireless connection module
LEDs
LEDs Description
Fuse:
Red LED
● On: The internal fuse has tripped.  Page 100, chapter
11.1.
System:
Yellow LED
● On: A wireless connection between up to five wireless
connection modules has been established.
● Double blinking: The internal system grid repeater function
temporarily supports combination of several wireless con-
nection modules into a system.
Master:
Green LED
● On: Wireless connection module is configured as master.
● Off: Wireless connection module is configured as slave.
● Blinking Internal system grid repeater function active.
Zone,
LED Power
(blinking simulta-
neously)
● Blue (Cool):
● Red (% rH):
● Yellow (NO):
Zone 1
Zone 2
Zone 3
Pump:
Green LED
● On: Pump on
● Off: Pump off
C/O Out:
Green LED
The function of the LED "C/O Out" is depending on the set-
tings of parameters P-51.  See also parameter description,
page 92.
● Function "Burner" active: On: heating demand
● Function "C/O" active: On: cooling demand
Power:
Green LED
● On: Power supply on
● Off: Power supply off