28
Click View Details following the icon to obtain information about the
uplink device and RSSI.
5. Configuration Steps for Wired Pairing (Uplink Device is an AP, EG
Router, or EGW Router)
Caution
The new AP must be in factory status.
It can be scanned only when the live network is enabled with Mesh (see 3.19
Enabling Reyee Mesh for details).
(1) Plug one end of the Ethernet cable to the uplink port of the new AP, and the other end
to the downlink port of an AP, EG router, or EGW router on the target network. Mesh
networking takes one to three minutes. When the system status LED is steady on, it
indicates that Mesh networking finishes.
To Next Page
Loading...
