30
6. Enabling WAN Port
The WAN port works as the wired uplink port of the AP by default. For the AP added to
the target network through Mesh pairing, the WAN port is disabled by default. If you
want to connect the Mesh AP to other downlink device in wired mode to expand the
network, enable this port.
(1) Log in to the Eweb of a device on the target network. In Network mode, choose
Devices > AP and click the serial number of the Mesh AP with the WAN port to be
enabled.
(2) Choose More > Advanced > Enable WAN, toggle on Enable, and click Save.
To Next Page
Loading...
