SAME SILVER 80 - Page 461

Menu 1 Menu 2
Menu 3 Menu 4
Menu 5 Menu 6
Menu 7 Menu 8
Menu 9 Menu 10
Menu 11 Menu 12
V
Transmission
Hydrive
3
31
1 - CALIBRATIONS
2 - TESTS
3 - CLUTCH CALIBRATION
4 - ALARMS
MENUS
( E ) EXIT
CLUTCH CALIBRATIONS
FULLY DEPRESS CLUTCH
AND PRESS(B)TOSAVE
THE 0% VALUE,THEN RELEASE AND PRESS
(A) TO SAVE THE 100% VALUE
CURRENT VALUE - 000% - 095
SENSOR MEAS.->172
CURRENT VALUE - 100% - 190
TESTS AVAILABLE
( E ) EXIT
1 - CLUTCH ped.
2 - OPTIONAL
( E ) EXIT
SELECT
1 - ARMREST JOYSTK. X
2 - GROUP – HML X
3 - EL. ENG. GOV. X
4 - NOT USED--
5 - EVP - COMAT. --
6 - EVP - DISA X
7 - EVP - BOSCH --
8 - NOT USED--
KEY:
X = ENABLED -- = DISABLED
( B ) SAVE ( C ) RENEW
CALIBRATION
FIRMWIRE S 1.4 A
PRESS A KEY
HML & REVERSER
MENUS
1 - ENGINE ECU
2 - HML & REV
SELECTION:__
WARNING !!!!
IN THE MONITORS THE TRACTOR IS
100% OPERATIVE!
0 - MISC.
1 - CONTROLS
2 - DIAGNOSTIC
( E ) EXIT
TEST & MONITORS
( E ) EXIT
( E ) EXIT
PRX - PEDAL 00000
PRX - AUTOM. 00000
PRX . TOTALE 00000
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
ENGINE TRANSMISS.
PED. T.OIL = 020
000% - - - - - - - - - - - - - - - - - - -
: GEAR:
POW 3 z A M NR
-125%
| - - - - - - - - - - - - - - - - - - -
RPM REV. | WH.
00000 RPM | Km/h
- SVC 00000 | 00.0
| - ( ) - | - - - - - -
REVCM 20.5V
A - REV 00.0V
1 - EVP 0.00A
2 - EVD 0.00A
B - HML 00.0V
3 - EVL 0.00A
4 - EVM 0.00A
5 - EVH 0.00A
EN - AL
ENREV - - - - - - - - - - - - - - - - - - - - - - -
ENHML - - - - - - - - - - - - - - - - - - - - - - -
( C ) RESET
SOLENOID VALVE TESTS
( E ) EXIT
TESTS MENU
1 - TEST EVS
2 - AUTOTEST EVS
3 - TEST H/W
DISABLE / ENABLE
(IN ORDER OF PRIORITY)
NO ALARM
( E ) EXIT
DIAGNOSTICS
VOUT - - - - - - 05.0 V
V6 V2 - - - - - - 07.3 V
A) BEEP ---------------------
( E ) EXIT
HARDWARE TEST
www.maskinisten.net
www.classicmachinery.net