SAMSUNG Programming
DCS-816 February, 1999
MMC 500 (Page 1 of 2)
MMC: 500 SYSTEM–WIDE COUNTERS
DESCRIPTION:
Used to set the values of the system counters. The counters are listed below with a
brief description of each.
0 ALARM REM. CNTER The number of times that an alarm reminder will ring a
station before cancelling. RANGE = 1–99.
1 AUTO RDL COUNTER The number of times the system will redial an outside
number after the auto redial feature has been
activated. RANGE = 1–15.
2 DISA CALL CNTER Sets the maximum number of intercom calls that can
be made after accessing a DISA line. RANGE = 1–99.
3 DISA LOCK CNTER Number of attempts the system will allow to incorrectly
access a DISA line before locking out the DISA line.
RANGE = 1–99.
4 NEW CALL COUNTER Number of times the system will allow a user to signal
New Call on a C.O. line during one call. RANGE =
1–99.
5 UCD VISUAL ALARM Used to set the Visual alarm threshold. It is triggered
when the number of calls waiting to be answered in the
UCD group reaches this value. RANGE = 0–25.
6 UCD AUDIO ALARM Used to set the Audio alarm threshold. It is triggered
when the number of calls waiting to be answered in the
UCD group reaches this value. RANGE = 0–25.
7 UCD CS LEVEL 1 Provides call wait indication level 1 if number of calls
waiting to be answered in UCD group reaches this
value. RANGE = 0–25.
8 UCD CS LEVEL 2 Provides call wait indication level 2 if number of calls
waiting to be answered in UCD group reaches this
value. RANGE = 0–25.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
To Next Page
Loading...
