EasyManua.ls Logo

Samsung DCS-816 - Page 127

Samsung DCS-816
313 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAMSUNG Programming
DCS-816 February, 1999
MMC 501 (Page 3 of 7)
RECALL WAIT TIME 15 SEC 1255 SEC
SMDR START/DP 30 SEC 1255 SEC
SMDR START/DTMF 15 SEC 1255 SEC
SYS HOLD RECALL 45 SEC 0255 SEC
TRANSFER RECALL 20 SEC 0255 SEC
UCDS AUDIO ALARM 0 SEC 0255 SEC
UCDS VISUAL ALAM 0 SEC 0255 SEC
PERI UCD REPORT 5 SEC 3-99 SEC
TIMER DESCRIPTIONS
AA INT DGT TIME: This timer controls the grace period between dialling valid
digits before transferring call to INVLID DEST as set in
MMC 733 on a perplan basis.
AA NO ACT TIME: If no digits are received by the AA module, this timer
expires and transfers the call to the destination set in
MMC 733 NO ACT DEST. This timer is usually called as
first digit timer after entering AA mode.
AA TRANS TIME: After this time, compare input digit with AA translation
table (MMC 732) and transfer to destination
ALERT TONE TM: This timer sets the duration of the attention tone
preceding a call to a keyset in the Voice Announce or
Auto Answer mode. This tone also precedes a forced
Auto Answer call.
ALM REM INTERVAL: This timer controls the time length between ring attempts
at a station when alarm reminder is set.
alarm reminder ring (1
st
)
ß
interval
à
alarm reminder ring (2
nd
)
ALM REM RING OFF:This timer controls the length of the ring cycle when alarm
reminder is set at a station.
ATT RECALL TIME: This is the length of time a transfer recall will ring at a
station before recalling the operator.
E
hold
ß
e
hold recl time
à
recall to
ß
att recall
à
recall to
ß
recall
à
disconnect
U
hold sys hold recall originator time operator disc. time
transfer transfer recall
AUTO REDIAL INT: This timer controls the time between attempts after
RETRY dialling is set on a station.
press RETRY
ß
auto redial
à
1st auto
ß
auto redial
à
2nd auto
when busy/rback interval redial interval redial
AUTO REDIAL RLS: This timer controls the duration of a Ring No Answer
condition on a retry number dialled before the auto redial
is automatically cancelled.
BARGEIN TONE This timer controls the intervals between the tones sent
INT: to the person who is being barged in on.

Table of Contents

Other manuals for Samsung DCS-816

Related product manuals