Samsung DCS-816 - Page 131

SAMSUNG Programming
DCS-816 February, 1999
MMC 501 (Page 7 of 7)
2) If Originator is occupied:
e – hold ß e – hold recall time à recall to originator ß recall à recall to ß recall à
disconnect
transfer trsf recall time with off hook ring wait time operator disc.time
SMDR START/DIAL This grace period timer starts SMDR recording for rotary
PULSE (ROTARY): dialling. This timer also controls the LCD duration timer
on the keysets. The duration time displayed and the
SMDR time duration will be the same.
SMDR START/DTMF: This grace period timer starts SMDR recording for
touchtone dialling. This timer also controls the LCD
duration timer on the keysets. The duration time
displayed and the SMDR time duration will be the same.
SYS HOLD RECALL: This timer determines the time calls can be left on hold
before recalling the holding station. This is a system–wide
timer. Setting timer to 000 means no recalling will take
place.
TRANSFER RECALL: This timer determines the time transferred calls ring
before recalling. This is a system–wide timer. See Recall
Wait Time.
UCDS AUDIO ALM: This timer determines how long the longest waiting call
can be held before the system gives an audio alarm to the
UCD supervisor.
UCDS VISUAL ALAM: This timer determines how long the longest waiting call
can be held before the system gives a visual alarm to the
UCD supervisor.
VMS UCD MSG TM: This timer controls the duration of time that VMS gives
UCD busy indication to user.
PERI UCD REPORT: This is periodic time for printing out UCD data.