Samsung DCS-816 - Page 182

SAMSUNG Programming
DCS-816 February, 1999
MMC 714 (Page 1 of 3)
MMC: 714 DID NUMBER AND NAME TRANSLATION
DESCRIPTION:
Provides a method of assigning an incoming DDI call through ISDN to a specific
station. If you have specified DDI service with your Network Carrier, you can match
each DDI number to specific stations using this command according to the day or
night mode. You also have the option, when the destination station is busy, of
deciding if the call is to be camped on to the destination station or of clearing the
call.
There is an extra option to adjust the number of digits to be compared by skipping
the programmed counts from the first digit point provided by the Network. If there is
no matching number in DDI NUMBER TABLE, the system routes this call to the
operator group.
There is a total of 50 entries in the system and each entry consists of the following
fields:
0 DIGITS Digits to be received (max. 12 digits). Wild card (Q) is
valid entry.
1 DAY DEST Destination in day mode. Can be a station, a station
group, a trunk or trunk group. Repeat (B) will be
acceptable to bypass.
2 NIGHT DEST Destination in day mode. Can be a station, a station
group, a trunk or a trunk group. Repeat (B) will be
acceptable to bypass.
3 CALL WAIT Toggles YES or NO.
4 NOF DEL DGT Decides the number of digits not to be translated from the
first digit received. This is useful when the received digits
are prefixed with the same digit(s).
5 NAME Gives a name to an individual entry (11 characters
maximum).
Names are written using the keypad in the same manner as SPEED NAME. Refer
to table below.
COUNT 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y Z 9
DIAL Q : = [ ]
Q