SAMSUNG Programming
DCS-816 February, 1999
MMC 722 (Page 1 of 4)
MMC: 722 STATION KEY PROGRAMMING
DESCRIPTION:
Allows the customising of programmable keys on specific electronic keysets on the
DCS-816 system. Buttons 1 and 2 are set as CALL buttons by default. Features
are entered via dial pad keys by pressing the dial pad number the required steps to
select the feature. For example, for OHVA, the number 6 is pressed three times. If
the BOSS key is required, press 2 twice for the first letter B and then use the UP or
DOWN key to change the selection from BARGE to BOSS.
DIAL KEYPAD
COUNT 1 2 3
DIAL 2 AAPLAY BARGE CALL
DIAL 3 DICT DICT FAUTO
DIAL 4 GPIK HDSET IOG
DIAL 5 LCR LCR LCR
DIAL 6 MMPA NEW OHVA
DIAL 7 PAGE REJECT SG
DIAL 8 TG UA VG
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Press TRSF 722
Display shows
[201] KEY (MAST)
01:CALL1
→
2. Enter station number (e.g., 205)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key
[205] KEY (MAST)
01:CALL1
→
3. Enter key number (e.g., 18)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key
OR
Press programmable button
[205] KEY (MAST)
18:NONE
→
_
To Next Page
Loading...
