Samsung DCS-816 - Page 97

SAMSUNG Programming
DCS-816 February, 1999
MMC 404 (Page 1 of 2)
MMC: 404 TRUNK NAME
DESCRIPTION:
Allows a name (up to 11 characters) to be entered to identify an individual trunk.
Names are written using the keypad. Each press of a key selects a character.
Press the desired key to move the cursor to the next position. For example, if the
directory name is “ SAM SMITH,” press the number “ 7” four times to get the letter
“ S.” Now press the number “2” once to get the letter “A.” Continue selecting
characters from the table below to complete your message. Pressing the “ A” key
changes the letter from upper case to lower case.
NOTE
When the character you want appears on the same dial pad key as the previous character, press
the UP key to move the cursor to the right or the DOWN key to move the cursor left. A space can
be entered by using these keys.
COUNT

1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y Z 9
DIAL Q : = [ ]
Q
The # key can be used for special characters: #, space, &, !, :, ?, ., %, $, –, <, >, /,
=, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
PROGRAM KEYS
UP & DOWN Used to scroll through options/move cursor left or right
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
A Key 19; acts as toggle between upper case and lower case
ACTION DISPLAY
1. Press TRSF 404
Display shows
[701] TRUNK NAME
2. Dial trunk (e.g., 704)
OR
Press UP or DOWN to select trunk and press
RIGHT soft key to move the cursor
[704] TRUNK NAME