Santec TSL-710 - Page 84

7-30
TSL-710 Operation Manual
:TRIGger:OUTPut
Syntax :TRIGger:OUTPut <wsp> <value>
Description Sets the timing of the trigger signal output.
Parameter 0：None
1：Stop
2：Start
3：Step
Response None
Example :TRIG: OUTP 1
Sets the timing of the trigger signal output to be at
sweep completion.
:TRIGger:OUTPut?
Syntax :TRIGger:OUTPut?
Description Reads out the timing setting of the trigger signal output.
Parameter None
Response 0：None
1：Stop
2：Start
3：Step
Example :TRIG:OUTP?
→ 2
Indicates that the timing of the trigger signal output
is at sweep start.
:TRIGger:OUTPut:STEP[:WIDTh]
Syntax :TRIGger:OUTPut:STEP[:WIDTh]<wsp><value>
Description Sets the interval of the trigger signal output.
Parameter Range：0.0001 〜 160 （ nm）
Step：0.0001（nm）
Response None
Example :TRIG:OUTP:STEP 1
Sets the interval of the trigger signal output.
:TRIGger:OUTPut:STEP[:WIDTh]?
Syntax :TRIGger: OUTPut: STEP [:WIDTh]?
Description Reads out the interval of the trigger signal output.
Parameter None
Response Range：0.0001 〜 160 （ nm）
Step：0.0001（nm）
Example :TRIG:OUTP: STEP?
→ 10.000
Indicates that the trigger signal output interval is 10 nm.