Santec TSL-710 - Page 83

Tunable Semiconductor Laser TSL-710
7-29
2）Input /Output related command
:TRIGger:INPut:EXTernal
Syntax : TRIGger: INPut: EXTernal <wsp> <value>
Description Sets Enable/Disable of the external trigger signal input.
Parameter 0：Disable
1：Enable
Response None
Example :TRIG:INP:EXT 1
Enables the external trigger signal input.
:TRIGger:INPut:EXTernal?
Syntax :TRIGger:INPut:EXTernal?
Description Reads out the setting of the external trigger
signal input.
Parameter None
Response 0：Disable
1：Enable
Example :TRIG:INP:EXT?
→ 1
Indicates that the external trigger is enabled.
:TRIGger:INPut:STANdby
Syntax :TRIGger: INPut: STANdby <wsp> <value >
Description Puts the device in trigger signal input standby mode.
Parameter 0: Normal operation mode
1: Trigger standby mode
Response None
Example : TRIG: INP: STAN 1
Puts the device in trigger standby mode.
:TRIGger:INPut:STANdby?
Syntax :TRIGger:INPut:STANdby?
Description Reads out the trigger signal input standby mode.
Parameter None
Response 0: Normal operation mode
1: Trigger standby mode
Example :TRIG:INP: STAN?
→ 1
Indicates that the device is in trigger standby mode.