Santec TSL-710 - Page 82

7-28
TSL-710 Operation Manual
:SYSTem:COMMunicate:SERial:SPEed?
Syntax
:SYSTem:COMMunicate:SERial:SPEed?
Description Reads out the speed of serial
communication.
Parameter None
Response 0：2400 bps
1：4800 bps
2：9600 bps
3：19200 bps
Example :SYST:COMM: SER:SPE?
→ 2
Indicates that the serial communication
speed is ”9600 bps”.
:SYSTem:COMMunicate:SERial:DELimiter
Syntax : SYSTem:COMMunicate:SERial:DELimiter<wsp> <value>
Description Sets the command delimiter for serial communication.
Parameter 0：CR
1：LF
2：CR+LF
Response None
Example :SYST:COMM:SER:DEL 1
Sets the command delimiter for serial
communication to “LF”.
:SYSTem: COMMunicate: SERial: DELimiter?
Syntax : SYSTem:COMMunicate:SERial:DELimiter?
Description Reads out the command delimiter for serial
communication.
Parameter None
Response 0：CR
1：LF
2：CR+LF
Example : SYST:COMM:SER:DEL?
→ 1
Indicates that the serial communication
delimiter is ”LF”.