Santec TSL-710 - Page 81

Tunable Semiconductor Laser TSL-710
7-27
Parameter None
Response Integer from 1 to 30
Example :SYST:COMM:GPIB:ADDR?
→ 10
Indicates that the GPIB address is “10”.
:SYSTem:COMMunicate:GPIB:DELimiter
Syntax :SYSTem:COMMunicate:GPIB:DELimiter<wsp> <value>
Description Sets the command delimiter for GPIB communication.
EOI is always sent.
Parameter 0：CR
1：LF
2：CR+LF
3：None
Response None
Example :SYST:COMM:GPIB:DEL 1
Sets the GPIB command delimiter to “LF”.
:SYSTem:COMMunicate:GPIB:DELimiter?
Syntax :SYSTem: COMMunicate: GPIB:DELimiter?
Description Reads out the command delimiter for
GPIB communication.
Parameter None
Response 0：CR
1：LF
2：CR+LF
3 : None
Example : SYST:COMM:GPIB:DEL?
→ 1
Indicates that the GPIB delimiter is ”LF”.
:SYSTem:COMMunicate:SERial:SPEed
Syntax :SYSTem:COMMunicate:SERial:SPEed<wsp> <value>
Description Sets the speed of serial communication.
Parameter 0：2400 bps
1：4800 bps
2：9600 bps
3：19200 bps
Response None
Example : SYST:COMM:SER:SPE 2
Sets the serial communication speed to “9600 bps”.