Santec TSL-710 - Page 88

7-34
TSL-710 Operation Manual
[:SOURce]:POWer[:LEVel]
Syntax [:SOURce]: POWer [:LEVel ] <wsp> <value>
Description Sets the optical output power.
Parameter Range: 30dB up to peak power
Typical value
-20 ~ +10dBm (0.01 ~ 10mW)
The available range of output power
depends on the product characteristics.
Step: 0.01dBm (0.01mW)
Set the unit with the [:SOURce]:POWer:UNIT
command in advance.
Response None
Example : POW 5
Sets the power to 5 dBm or 5 mW depending on
the value set for the unit.
[:SOURce]:POWer[:LEVel]?
Syntax [:SOURce]:POWer [:LEVel][:MINimum|:MAXimum]?
Description Reads out the setting value of the optical output power.
Parameter None Reads out the currently set wavelength.
MINimum:
Reads out the minimum available output power.
MAXimum:
Reads out the maximum available output power.
Response Range: 30dB up to peak power
Typical value
-20 ~ +10dBm (0.01 ~ 10mW)
The available range of output power
depends on the product characteristics.
Step: 0.01dBm (0.01mW)
The unit is previously set with the
[:SOURce]:POWer:UNIT command.
Example :POW?
→ 10.000
Indicates that the optical output power is either 10 dBm
or 10 mW depending on the value set for the unit.
[:SOURce]:POWer:ACTual[:LEVel]?
Syntax [:SOURce]:POWer:ACTual[:LEVel]?
Description Reads out the monitored value of the optical output
power. The monitored value is the value actually
measured by the self-contained power monitor.