Sartorius BioPAT Trace - Active Access Restriction | Log in

68 BioPAT
®
Trace | Multi Trace Operating Instructions
Initial Installation
6.7 Active Access Restriction | Log in
To activate the access restriction – by means of
which the menu functions are assigned to the
various responsible operators – the access
privileges can be adjusted using the Login start
command “-L”.
The device opens then when you first start the
administrator mode. The administrator then
creates other operators and gives them the
access rights (group 0-2). For all subsequent
starts initially only the lowest access level
(group0) is active and the respective operator
must authorize himself using the menu item
“Login” (see Chapter “8.3.10 Menu Item
“Log in””, page 105).