Sartorius BioPAT Trace - Loading the Software and Network Connection

BioPAT
®
Trace | Multi Trace Operating Instructions 63
Initial Installation
6.4 Loading the Software and
Network Connection
The BioPAT
®
Trace | Multi Trace is run internally
by a computer and can be operated as a full-
ranked member in intranets and LANs, or can be
directly interfaced with a PC.
In order to do this, the operating software
supplied must be installed on the designated PC.
The files needed for the installation of the
operating software trace_mon are stored in the
devices’s data memory and can be accessed via
an internal device website.
To install the software, proceed as follows:
t Connect the BioPAT
®
Trace | Multi Trace to
your network and navigate to the factory-set
IP address 192.168.120.231 in your web
browser. Here you have the option of down-
loading important files and the operating
instructions onto your computer and of
assigning the device an IP address appro-
priate for your own network.
t If you do not want to make any changes (if
there is a direct connection with a PC via a
cross-over Ethernet cable, for example), then
the device will work with the factory-set IP
address. Make sure that your PC is not set to
automatic address assignment when using a
direct connection!