BioPAT
®
Trace | Multi Trace Operating Instructions 75
Operation
8 Operation
Switch on the BioPAT
®
Trace | Multi Trace at the
On/off switch located on the rear panel and run it
on an external PC.
You will find the start icon on the PC’s
desktop
. Double-clicking it will start the
application. The user interface shown in the
adjacent figure appears.
The device number appears in the header. In this
case: 231*. The asterisk indicates that a connec-
tion exists between the control PC and the
BioPAT
®
Trace | Multi Trace. If there is no connec-
tion to the measuring instrument, it must be
established (see Chapter “6.1.1 Device Setup”,
page 39).
The measurement display can be modified at any
time during operation. Press the right mouse
button to display the input field for configuring
the view.
Here, you can configure dot sizes, dot colors and
the axis scales.
The default settings are the color blue for
glucose and red for lactate. A green dot color is
preset for methanol or ethanol.
The device status is displayed under the mea-
surement window. At the beginning, the device is
in default mode. To the right of the measuring
window there is an area for context-based selec-
tion buttons.
To Next Page
Loading...
