BioPAT
®
Trace | Multi Trace Operating Instructions 85
Operation
Once you have entered the correct IP address
and the device is acknowledged by the network,
it will connect to the control PC. An asterisk
appears in the view bar behind the name or
number of the device.
Alternatively, you can start a search for new
devices on the network by clicking on the button
“Who is out there?”. The results will be displayed
after a little while. You can highlight the desired
device and select it with “Ok”.
If no device can be found, an error message
appears. Try to enter the IP address directly or
contact your network administrator.
8.3.1.2 Startup
If the tubing set has been replaced, you must go
to the menu item “Startup”. “Startup” deactivates
all previous calibration and reference data and
requires that the tubing system is re-primed.
8.3.1.3 Cleaning
For longer waiting times the cleaning mode
should be used. For this purpose, all of the lines
of standards and transport buffer, and optionally
the sample feed has to be connected to the
cleaning solution (Order No. BPT0044A /
BPT0044G). Then in the menu “Device” the
option “Cleaning” is selected.
To Next Page
Loading...
