BioPAT
®
Trace | Multi Trace Operating Instructions 95
Operation
8.3.7.3 Basic Settings
In the “Basic Settings” menu item, you can enter
data that is important for carrying out and docu-
menting the measurements.
Before running the measurement, you can enter
the project name and device location. This infor-
mation will later be displayed in the header
enabling a better assignment of data to the pro-
cess, especially if several devices are in operation
at the same time.
You can either select between the dialysis for the
determination of glucose, lactate and ethanol, as
and the dialysis methanol | ethanol.
If glucose as sole parameter should be measured
the method dialysis-glucose can be selected. The
lactate measurement channel will be disabled in
this application.
CAUTION
Before working with a new tubing set, always
check to make sure that the right application
has been selected! Otherwise, this can result in
erroneous measurements or destruction of the
tubing set!
By placing a check mark next to “Set time”, you
can compare the system times on your PC and
the BioPAT
®
Trace | Multi Trace. It will then use
the PC’s system time.
To Next Page
Loading...
