EasyManuals Logo

SATO CG2 Series User Manual

SATO CG2 Series
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Section 8: Appendix
CG2 Series Operator Manual Page 8-13
8.8 PAPER END
8.8.1 Roll Label End
When the Label End is less than 10mm (0.4”) from I-Mark
The printer behavior when paper end is detected is as follows:
After completing the print of label (1), “Paper end error” will occur.
In cutter mode, “Paper end error” will occur after cutting the label.
After releasing the error, Label (1) will not be printed again.
When the Label End is More Than 10mm (0.4”) from I-Mark
The printer behavior when paper end is detected is as follows:
When the print of label (2) is in progress, “Paper end error” will occur.
If an error occurs while printing, label (2) will be printed again after releasing the error. If the print job is
completed at the time of error occurrence, label (2) will not be printed again.
In cutter mode, cutting motion will not occur when the printer has a “Paper end error.”
(1)
(2)
Paper feed direction
I-Mark
Less than 10mm
(0.4”)
(1)
(2)
Paper feed direction
I-Mark
More than 10mm
(0.4”)

Table of Contents

Other manuals for SATO CG2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SATO CG2 Series and is the answer not in the manual?

SATO CG2 Series Specifications

General IconGeneral
BrandSATO
ModelCG2 Series
CategoryPrinter
LanguageEnglish

Related product manuals