SATO CG2 Series - Local Area Network (LAN) Ethernet and Wireless LAN

Section 7: Interface Specifications
Page 7-8 CG2 Series Operator Manual
7.4 LOCAL AREA NETWORK (LAN) ETHERNET AND WIRELESS LAN
7.4.1 Basic Specifications of LAN
A Local Area Network (LAN) interface requires a driver shipped with each printer that has the interface
installed. The driver must be loaded on the host computer and configured to run one of the supported network
protocols using a 10/100BaseT LAN connection. Details for loading the LAN driver are contained in the LAN
Interface Manual that is shipped with each printer with a LAN Optional interface installed.
LAN interface is available with Type 2 board.
Interface connector
Cable type: For 10BASE-T and 100BASE-TX
Cable length: 100m or less
Link/Status LED Status LED lights up when establishing the LINK with Ethernet equipment. The
LINK is established by Auto Negotiation.
LED Color Conditions
LINK Green Lights up when establishing the LINK
SPEED Yellow Lights off when recognizing the destination
10BASE-T
Lights up when recognizing the destination
100BASE-TX
Maintenance function [Printing LAN configuration information]
LAN configuration information will be printed on the third sheet of user test print
and factory test print.
[Initializing LAN configuration information]
LAN configuration information will be initialized through [All Clear] of Factory
Clear Mode. For more details, refer to the authorized SATO servicing personnel.
Interface type Use Printer configuration tool or <DI> command.
<DI>a
Parameter Item Value Decription
a Interface
0 USB [Default]
1LAN
2Keypad