Section 7: Interface Specifications
CG2 Series Operator Manual Page 7-9
Communication
configuration
The following settings can be configured via the Printer configuration tool or com-
mands.
Item Command Setting range
LAN mode
<I3> Protocol for driver (STATUS4) cyclic
response mode *
1
Protocol for driver (STATUS4) ENQ
response mode *
1
STATUS3 *
2
IP address
<W1> 0.0.0.0 ~ 255.255.255.255
Subnet mask
<W2> 0.0.0.0 ~ 255.255.255.255
Gateway address
<W3> 0.0.0.0 ~ 255.255.255.255
IP address setup
<WI> Manual
DHCP
RARP
<WM> RARP disabled
RARP enabled
*
1
*
2
2-port connection by Port1024 and Port1025 or 1 port connection by
Port9100.
1 port connection by Port1024 or Port9100.
Maximum receive
buffer capacity
1MB
Near full occurred
Near full released
0MB
1MB
Remaining 0.25MB
Remaining 0.5MB
To Next Page
Loading...
Need help?
General
