SATO CG2 Series User Manual

Section 3: Operation and Configuration
CG2 Series Operator Manual Page 3-17
3.9 HEX DUMP MODE
HEX Dump Mode allows you to print the contents of the receive buffer in a hexadecimal format. This feature
allows the data stream to be examined for errors and troubleshooting.
After selecting the HEX Dump Mode in Operation Setting Mode, restart the printer (refer to Section 3.5
Operation Setting Mode). The printer then awaits data feeds and when data arrives, it prints out the HEX
data continuously.
To exit the HEX Dump Mode, restart the printer by turning off the printer and then on again.
3.10 PRINT MODE OF WIRELESS LAN SETTING
This mode produces print-out for wireless LAN setting. This is only available when the optional wireless LAN
interface unit is connected to the printer.
Preparation:
Make sure the media or ribbon (if required) are properly loaded in the printer.
(The printer will cyclically
advance to next mode as long
as the
FEED/LINE button is
held down.)
Solid red light
Printer start-up
While pressing
FEED/LINE button, press
POWER button.
Release POWER button
and keep holding
FEED/LINE button.
Solid green light
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to blinking red
light.
Blinking red light
Blinking green light
Press FEED/LINE button
to start printing.
Wireless LAN Setting
Print mode is activated
and then paused.
Solid green light
Wireless LAN Setting
Print start after initial feed
and print continuously.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
Wireless LAN Setting
Print paused.
Blinking green light
1
2
3
4
Printer statusProcedures ON LINE (POWER) indicator
User Test Print Mode.
Factory Test Print Mode
Operation Setting Mode.
Wireless LAN Setting Print Mode.
Solid red light
Blinking green light
Blinking red light

SATO CG2 Series Specifications

General

Brand	SATO
Model	CG2 Series
Category	Printer
Language	English