Section 3: Operation and Configuration
CG2 Series Operator Manual Page 3-27
3.16 MEASURES FOR RFID ERROR (OPTIONAL)
The printer equipped with this feature only if the optional RFID kit is installed.
If the number of tag write/read failures exceeds the maximum retry counts specified in [RFID tag error ignore
counts] or [Retry counts], the printer will indicate an error with ON LINE (POWER) indicator blinking and it will
pause to wait for key entry.
To restart the print, refer to the following operations.
Notes:
• If an “RFID tag error” is detected, the tag will be voided and marked as a defected tag.
• After performing the initial feed by the FEED/LINE button, the reprint will be performed.*
1
Briefly press the
FEED/LINE
button.*1
RFID error detected
ON LINE (POWER) indicator
Blinks red in the longest
interval
Pauses and waits for
key entry
Briefly pressing the FEED/LINE button will cause
printer to cycle through the following operations.
Press and hold the FEED/LINE
button for more than 3 seconds
to determine function
Reprint (1)
Cancel 1 item
print request (2)
JOB cancel
(Cancel print request
of all items) (3)
ON LINE (POWER)
indicator
ON LINE (POWER)
indicator turns off
ON LINE (POWER)
indicator turns off
ON LINE (POWER)
indicator turns off
ON LINE (POWER)
indicator lights green.
Printer enters Online
mode and starts reprint.
ON LINE (POWER)
indicator lights green.
Printer enters Online
mode and print the next
item.
ON LINE (POWER)
indicator blinks green.
Printer enters Offline
mode after canceling JOB.
Select
function
Cover open error detected
ON LINE (POWER) indicator
Blinks red
Open cover
Close cover
Enters Offline mode
ON LINE (POWER) indicator
Blinks green.
ON LINE (POWER)
indicator Lights green.
Printer enters Online
mode and starts reprint.
(1) Reprint (2) Cancellation of 1
item print request
(3) JOB cancel
(Cancel all
items)
lights red
Blinks red in long
interval
Blinks red in the
longest interval
To Next Page
Loading...
Need help?
General
