Section 3: Operation and Configuration
CG2 Series Operator Manual Page 3-1
OPERATION AND CONFIGURATION
Before using the printer, it is best to read this manual thoroughly. Otherwise, you may disturb default settings
on which the instructional procedures in this manual are based.
Most of the printer’s settings are controlled via standard SBPL commands or by using the provided SATO
Utilities Tool application.
Some printer settings may be manually configured via the POWER and FEED/LINE buttons with the ON LINE
(POWER) indicator on the front of printer and/or via the potentiometers located on the printer’s front and back.
All of the printer’s buttons, and potentiometers are used either singularly, or together, to perform configuration
activities. The instructions to these operations are described in this section.
To Next Page
Loading...
