SATO CG2 Series User Manual

Section 3: Operation and Configuration
CG2 Series Operator Manual Page 3-11
3.4 FACTORY TEST PRINT MODE (cont’d)
Second print-out (Settings)
This setting information is similar to the first print-out in user test print mode. Refer to Section 3.3.1 Output
Data of the User Test Print for details.
Third print-out (Interface)
This interface information is similar to the third print-out in user test print mode. Refer to Section 3.3.1 Output
Data of the User Test Print for details.
3.5 OPERATION SETTING MODE
The operation setting mode enables further selection of the functions of the printer. These are:
• Program download mode
• Font download mode
• Default setting mode
• HEX dump mode
• USB/ Wireless LAN interface
• RS-232C/ LAN interface
• Keypad selection
Selection of the above operation setting modes are as shown below.
Solid red light
Printer start-up
While pressing
FEED/LINE button, press
POWER button
Release POWER button
and keep holding
FEED/LINE button.
Solid green light
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to blinking green
light.
Blinking green light
Printer enters Opera-
tion Setting Mode.
1
2
3
Printer status Procedures ON LINE (POWER) indicator
User Test Print Mode.
Factory Test Print Mode
Operation Setting Mode
(The printer will cyclically
advance to next mode as
long as the FEED/LINE
button is held down.)
Solid red light
Blinking green
light
To be continued on the next page.

SATO CG2 Series Specifications

General

Brand	SATO
Model	CG2 Series
Category	Printer
Language	English