SATO CG2 Series User Manual

Section 3: Operation and Configuration
Page 3-12 CG2 Series Operator Manual
3.5 OPERATION SETTING MODE (cont’d)
Briefly press the
FEED/LINE button
repeatedly to select
different operation setting
mode cyclically.
Program Download
Mode
When the desired mode is
selected, press the
FEED/LINE button for
more than 3 seconds until
the ON LINE (POWER)
indicator is turned off.
Confirmation of the
selected mode.
Off (while pressing FEED/LINE)
4
Printer status Procedures ON LINE (POWER) indicator
Blinking green light
Font Download Mode
Solid red light
Default setting Mode
Blinking red light
HEX Dump Mode
Green→Red (Lights in turn)
USB/ Wirless LAN
interface
Green→Red (Blinks in turn)
RS-232C/ LAN
interface
Flashes green in a long interval
Keypad is selected*
Flashes red in a long interval
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
5
Completion of function
execution.
Changes to solid green light
after release of FEED/LINE
(except for download mode,
in which case it will change to
solid red light.).
Press the POWER button to
turn off the printer, then press
again to turn it on.
(NOTE: This step is NOT
required for download mode.)
The selected mode will
be valid by restarting
the printer.
6
* Keypad selection is only
available for USB/RS-232C
board printer. If Keypad is
selected, even if the keypad
device is not connected,
other interfaces cannot be
activated.
Briefly press =
press more than 1 second
but less than 3 seconds
(For download mode selection, the printer will continue to complete
the downloading process. Refer to section 3.6 and 3.7 for details.)

SATO CG2 Series Specifications

General

Brand	SATO
Model	CG2 Series
Category	Printer
Language	English