Section 3: Operation and Configuration
Page 3-24 CG2 Series Operator Manual
*1. Available for USB+RS-232C specification only.
*2. Available for USB+LAN specification only.
*3. Use SATO port or Port 9100 when sending print request from the printer driver.
*4. The printer will restart in specified mode.
27 LAN interface *2 LAN mode Protocol for driver(STATUS4)Cyclic response *3
Protocol for driver(STATUS4)ENQ response *3
1 port connection/ENQ response(STATUS3)
28 Non-standard code Nonstandard code
switching
Standard code/Nonstandard code
29 Nonstandard code
setting
Nonstandard code settings for STX, ETX, ESC,
ENQ, CAN, NULL, OFFLINE
30 Download Firmware download Download firmware from the host computer.
31 Reboot mode *4 (1) Start up in program download mode
(Available in normal operation mode only)
(2) Start up in normal operation mode
(Available in program download mode only)
No. Category Setting item Setting contents
To Next Page
Loading...
