SBC PCD2.M5 Series - Communication on Slot C

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG Communication interfaces
5
5-25
Communication on Slot C
5.7 Communication on Slot C
SlotCisintendedtotaketheinterfacefortheCAN-BusorforProbusapplications.
A2
A1
I/O Slots
C
PCD2.M5540
0
321
7
456
Fitting a circuit board to Slot C
● Removehousingcover(seesection3.5.3)
● Remove supply from the PCD2.M5_
● Removeanycablesalreadypluggedin(UBS,Ethernet,Probus,RS-232)
● Remove upper part of housing (seesection3.5.4)
● BeforeplacingacircuitboardonSlotC,insertPCD7.F1xxintoSlotA2if
required
● First,insertthetwospacersonthebackofthecircuitboards(seeFigs.1&2).
The rounded ends of the spacers must be inserted into the round holes in the
PCD board
● Turn the circuit board and insert into the holes provided in the CPU board
 EnsurethattheplugiscorrectlypositionedinSlotC(Fig.3)
 Fig.1   Fig.2     Fig.3