SBC PCD2.M5 Series - Pcd2.E11 X, 8 Digital Inputs

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Digital input modules
Input/output (I/O) modules
6-7
6
6.2.1 PCD2.E11x,8digitalinputs
Application
Low-cost input module for source or sink operation with 8 inputs, electrically
connected. Suitable for most electronic and electromechanical switching elements
at 24 VDC. The PCD2.E111 differs from the PCD2.E110 in its shorter input delay,
typically 0.2 ms.
Technical data
Number of inputs: 8 electrically connected,
source or sink operation
Input voltage E110 :
E111 :
E113 :
E116 :
Special :
24 VDC(15…30 VDC)smoothed or pulsed
24 VDC(15…30 VDC)smoothed, max. 10 % residual ripple
12 VDC(7.5…15 VDC)smoothed, max. 10 % residual ripple
5 VDC(1…7 VDC)smoothed, max. 10 % residual ripple
other values on request
Input current: 6 mA at 24 VDC
Input delay E110:
E111:
E112:
E116:
typ. 8 ms
typ. 0.2 ms
typ. 9 ms
typ. 0.2 ms
Resistance to interference:
acc. to IEC 801-4
2 kV under capacitive coupling
(wholetrunkgroup)
Internal current consumption:
(from+5Vbus)
1 … 24 mA
typ. 12 mA
Internal current consumption:
(fromV+bus)
0 mA
External current consumption: max.48mA(allinputs=1)from24VDC
Terminals: Pluggable10-polescrewterminalblock(440548470),for
wires up to 1.5 mm²
LEDs and connection terminals
9 8 7 6 5 4 3 2 1 0
E0E1E2E3E4E5E6E7
L
Bus connector
Bus interface and
Threshold switches
Input circuits
LEDs
Screw terminals
Inputs E0 to E7
Input load resistors
User ground -