SBC PCD2.M5 Series - CAN Bus, Module PCD7.F7400

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG Communication interfaces
5
5-26
Communication on Slot C
Checkthattheplugisinsertedcorrectly.Fix
the circuit board with the Torx T 10 screw
provided sichern.
Remove upper part of housing,
section 3.5.4
Push out pre-pressed aperture for the
D-Sub socket and replace upper part of
housing, section 3.5.4
5.7.1 CANbus,modulePCD7.F7400
TheCANbusshouldbeconnecteddirectlytothePCD7.F7400module.
PCD7.F7400 PCD7.F7400
to connect the CAN bus, 1 MBit/s
Pin layout, D-Sub 9 pole, CAN Port 10
Socket C
Connection type D-Sub9-pole(male)
signal Pin no
1
CAN_Low 2
GND 3
4
5
6
CAN_High 7
8
9