SBC PCD2.M5 Series - User Program Backup To The Flash Card

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
MemorymodulePCD3.R600forashcards(FCs)
PCD2.M5_ Classic CPUs and expansion housings
3-48
3
Inserting the ash card
Move slideronthePCD2.R6000totheOFF
position
Wheninsertingtheashcard,pressuntilyou
feelsomeresistance;youmayhearasoft
click. Ease off the pressure until the card is at
the same height as the slot.
Move slideron the PCD2.R6000 to the ON
position
TheSDcardisformattedwiththeSBCle
system(regardlessofthesettingoftheBCD
switch)
OFF
ON
1
2
Removing the ash card
Move slideronthePCD2.R6000totheOFFposition
Wait until the "Busy" LED is off. If the "Busy" LED is off, push the card into the module
housing until you feel some resistance. Ease off the pressure until the card slides out.
Reformatting the ash card
Move slideronthePCD2.R6000totheOFFposition
Wait until the "Busy" LED is off.
Turn BCD switchto position 5
Move slideron the PCD2.R6000 to the ON position
Wait until the "Busy" LED is off.
Remove and re-insert SD card
NB: This procedure deletes all stored data.
3.13.6 Userprogrambackuptotheashcard
Itispossibletobackuptheuserprogram(seesection3.12.1)totheashcardinthe
PCD2.R6000.
Thememorylocationsfortheuserprogram(tobackupandrestore)arequeriedin
the following order:
1. M1 Slot
2. M2 Slot
3. I/O Slot 0...3
 4.Onboardashmemory(wherepresent)