SBC PCD2.M5 Series - Page 121

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Digital input modules
Input/output (I/O) modules
6-10
6
For every 2 inputs, a 3-colour LED is tted:
LED is
I0 I1 I2 I3 I4 I5 I6 I7 I8 I9 I10 I11 I12 I13 I14 I15
off 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Red 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0
Green 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1
Yellow 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
SBCprovidesawiderangeofpre-conguredcableswitha34-poleribbonconnector
at one or both ends.
These connection cables can be plugged at one end into the PCD2.E160 I/O module
and at the other end into an I/O terminal adapter.
The following adapters are obtainable from SBC terminal adapters for connecting
3-wiresensorstoindividualterminalsforSignal,PlusandMinus;terminaladapters
forconnecting16I/OswithandwithoutLEDandrelayinterface;andterminal
adapters with changeover contacts for signal conversion for digital output modules.
FurtherinformationcanbefoundintheManualon"System cables and connection system"
26/792.
The following materials can be ordered from ‘3M’:
● Socket connector 34-pole Type 3414-6600
● (Metalstrainrelief)*)    Type3448-2034
● (Handleforsocketconnector34-pole)*) Type3490-3
Matching cables can be ordered in reels from '3M':
● Ribbon cable 34-pole,
 greywithpin1identication  Type3770/34or3801/34
● Round cable 34-pole,
 greywithpin1identication  Type3759/34
 *)optional