SBC PCD2.M5 Series - Page 124

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Digital input modules
Input/output (I/O) modules
6-13
6
For every 2 inputs, a 3-colour LED is tted:
LED is
I0 I1 I2 I3 I4 I5 I6 I7 I8 I9 I10 I11 I12 I13 I14 I15
off 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Red 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0
Green 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1
Yellow 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Input circuits and terminal designation
Depending on external wiring, this module may be used for source or sink operation.
Source operation (positive logic):
10 k 10 k
10 k 10 k
E1 E0L L
19 18 17 16 1 0
Ue 24 VDC
LED red
LED green
Screwless terminals
If both inputs 0 and 1 are
switched on, the yellow
(orange) LED lights up
Switch closed (+ at input): signal state "H", LED lights up
Switch open: signal state "L", LED off
Sink operation (negative logic):
E1 E0L L
19 18 17 16 1 0
Switch closed (- at input): signal state "L", LED off
Switch open: signal state "H", LED lights up
Screwless terminals
Ue 24 VDC
Watchdog: This module can interact with the watchdog, if it is used on base address
240. In this case, the last input with address 255 cannot be used.
Fordetails,pleaserefertothe"Watchdog" section, which describes the correct use of
the watchdog in conjunction with PCD2 components.