SBC PCD2.M5 Series - Page 132

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Digital output modules
Input/output (I/O) modules
6-21
6
Output circuits and terminal designation
A0
0
8
9
7
I/O Bus
PCD Bus
24 VDC
Fuse
6
5
A5
Output
transistors
(MOSFET)
Protective
diodes
Terminals
Loads
LED
address A5
Outputconducting(set):  LEDon
Outputdisconnected(reset): LEDoff
Fuse: It is recommended that each module should be separately protected with a
 fast-blow(S)fuseofmax.12.5A.
Watchdog:Thismodulecanbeusedonallbaseaddresses;thereisnointeractionwiththe
watchdogontheCPUs.Fordetails,pleaserefertothe"Watchdog" section, which describes
the correct use of the watchdog in conjunction with PCD2 components.