SBC PCD2.M5 Series - Page 139

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Digital output modules
Input/output (I/O) modules
6-28
6
For every 2 outputs, a 3-colour LED is tted:
LED is
O0 O1 O2 O3 O4 O5 O6 O7 O8 O9 O10 O11 O12 O13 O14 O15
off 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Red 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0
Green 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1
Yellow 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Output circuits and terminal designation
Screwless
terminals
Loads
A15 A14
10...32 VDC
A13 A12 A11
8 bit latch
LEDs
18,19 16,17
15 14 13 12
11
Watchdog: This module can interact with the watchdog, if it is used on base address 240. In
this case, the last input with address 255 cannot be used.
Fordetails,pleaserefertothe"Watchdog" section, which describes the correct use of the
watchdog in conjunction with PCD2 components.