SBC PCD2.M5 Series - Page 199

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Counting module
Input/output (I/O) modules
6-90
6
Programming: Based on PCD user program and pre-programmed
functionblocks(FB).
Count modes: Selectable with jumper
Terminals: Pluggable10-polescrewterminalblock(440548470),
for wires up to 1.5 mm²
LEDs and connection terminals
“A”  Input“A” 1
“B”  Input“B” 2
“En”(Enable) Counteractive 0
“CCO”  Output“CCO”3
9 8 7 6 5 4 3 2 1 0
A B CCO
CCO B A En
SC
x1
x2
Bus connector
GAL*) for adressing
GAL*) for count modes
Jumper for count modes
LEDs
Screw terminals
(*) GAL = Generic Array Logic)
Changing the jumpers
On this circuit board there are components that are sensitive to electrostatic dis-
charges.Forfurtherinformation,refertoAppendixB,"Icons"