SBC PCD2.M5 Series - Page 230

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
CPUs
Conguration
8-6
8
Reset Output Enable
If the CPU goes into Halt mode, all outputs are set to 0.
XOB 1 Enable
Where PCD2/3.Cxxxx module holders are used, a cable break or power outage is
displayedbycallingXOB1.
Run/Halt Switch Enable
Run
Halt
The Run/Halt switch is activated. On the PCD2.M5_, it is thus
possible to manipulate the operating mode with the switch that is
accessible on the top of the CPU
Full RS-232 handshaking on Port 0
This allows Port 0 to be used as a normal serial port or as a modem interface.
If this option is enabled, it will no longer be possible to communicate with the CPU
via the PGU port. This seting should only be used when the USB port or the Ether-
net connection are being used for programming.
Alltheseoptionsarewrittentothe“ashcard”whenthesettingsarebackedup.