Seat Ateca 2017 - Page 340

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Lambda probe heater - Z19-
❑ Location ⇒ page 341
❑ Removing and fitting ⇒ page 388
6 - Turbocharger air recirculation valve - N249- and charge pressure positioner - V465-
❑ Components fitted directly on turbocharger
❑ Installation location position sender for charge pressure positioner - V465- ⇒ page 341
❑ Fitting location turbocharger air recirculation valve - N249- ⇒ page 342
❑ Removing and fitting ⇒ page 307
7 - Hall sender 3 - G300-
❑ Location ⇒ page 336
❑ 9 Nm
❑ Removing and fitting ⇒ page 455
8 - Brake light switch - F- and Brake pedal switch - F47-
❑ Location ⇒ page 335
❑ Removing and installing ⇒ Brake system; Rep. gr. 45 ; Overview of fitting locations; Overview of fitting
locations - ABS/ESP
9 - Electrical connectors
❑ For Lambda probe 1 before catalytic converter - GX10- .
❑ For Lambda probe 1 - GX7- (after catalytic converter)
❑ Location ⇒ page 341
10 - High-pressure pump with fuel metering valve - N290- .
❑ Location ⇒ page 339
❑ ⇒ page 380
❑ Removing and fitting ⇒ page 381
11 - Coolant temperature sensor - G62-
❑ Location ⇒ page 339
❑ Removing and fitting ⇒ page 268
❑ 9 Nm
12 - Engine control unit - J623-
❑ Removing and fitting ⇒ page 376
13 - Hall sensor - G40-
❑ Location ⇒ page 337
❑ Removing and fitting ⇒ page 455
❑ 9 Nm
14 - Vacuum unit for intake manifold flaps
❑ Location ⇒ page 338
15 - Connector for injectors (intake manifold)
16 - Intake manifold flap valve - N316-
❑ Location ⇒ page 338
17 - Engine speed sensor - G28-
❑ Location ⇒ page 339
❑ Oil seal
❑ Replace bolt
❑ 4 Nm and turn 45° further
❑ Removing and fitting ⇒ page 456
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
332 Rep. gr.24 - Mixture preparation - injection