Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Throttle valve drive angle sender 2 (electric power control) - G188-
❑ After replacing or removing, the throttle valve module - GX3- must be adapted to the engine control unit
- J623- . ⇒ Vehicle diagnostic tester
❑ Location ⇒ page 340
23 - Ignition coils with output stages
❑ Location ⇒ page 337
❑ Removing and fitting ⇒ page 452
24 - Fuel pressure sensor - G247-
❑ Location ⇒ page 338
❑ 27 Nm
❑ Removing and fitting ⇒ page 369
25 - Activated charcoal filter solenoid valve 1 - N80-
❑ Location ⇒ page 336
26 - Intake manifold flap potentiometer - G336-
❑ Location ⇒ page 338
27 - Coolant temperature sender at the radiator outlet - G83-
❑ Location ⇒ page 340
❑ Removing and fitting ⇒ page 268
28 - Supercharging pressure sender - G31-
❑ Location ⇒ page 340
❑ Removing and fitting ⇒ page 326
29 - Valve for oil pressure control - N428-
❑ Location ⇒ page 340
❑ Removing and fitting ⇒ page 231
30 - Oil pressure switch - F1- , oil pressure switch for reduced oil pressure - F378- and piston cooling jet control
valve - N522-
❑ Location ⇒ page 340
❑ Removing, installing and testing ⇒ page 227
A - Injectors, direct injection
❑ Location ⇒ page 337
❑ Cylinder 1 injector - N30-
❑ Cylinder 2 injector - N31-
❑ Cylinder 3 injector - N32-
❑ Cylinder 4 injector - N33-
❑ Removing and fitting ⇒ page 346
B - Injectors, intake manifold injection
❑ Location ⇒ page 337
❑ Cylinder 1 injector 2 - N532-
❑ Cylinder 2 injector 2 - N533-
❑ Cylinder 3 injector 2 - N534-
❑ Cylinder 4 injector 2 - N535-
❑ Removing and fitting ⇒ page 349
C - Fuel pump control unit - J538-
❑ Location ⇒ page 336
❑ Removing and installing ⇒ Rep. gr. 20 ; Fuel pump
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
334 Rep. gr.24 - Mixture preparation - injection