Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Cut off nozzle on tube at front marking (∅ of nozzle approx. 2
mm).
– Apply silicone sealant as shown to clean sealing surface of
sealing flange.
♦ Thickness of sealant bead: 2 to 3 mm.
Note
♦
The sealing flange must be installed within 5 minutes after ap‐
plying the silicone sealant.
♦
The line of sealant must not be thicker than prescribed, as
otherwise excessive sealant will enter the sump and obstruct
the strainer in the oil intake pipe.
♦
Check sealing flange; it must be free of kinks and damage.
♦
The sealing lip must face engine following installation. If the
sealing lip is pressed outwards during installation, there may
be loss of oil due to leakages.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2. Cylinder block, gearbox end 77
To Next Page
Loading...
