113
7 Ethernet Setup
Normally, it is necessary to set up a fixed TCP/IP address for the computer to
communicate with the DAQlink III unit.
IP Address SET to FIXED IP ADDRESS – 192.168.0.101
All Firewalls Disabled
7.1 Windows VISTA Operation
When using Windows Vista Operating System the VSCOPE program cannot be installed
in the Program Files subdirectory.
A new subdirectory on the C drive should be made and the Vscope.exe should be copied
to this subdirectory.
IP address setup must be set to a fixed IP address and all firewalls must be disabled.
Disable the Windows Firewall by selecting the Firewall selection in the “Network and
Internet” selection in the Control Panel
With Windows Vista computer, the Ethernet setup is done by the following procedure:
Go to the Control Panel and select “View network status and tasks”.
To Next Page
Loading...