8 User’s Manual
Status LED’s on front panel
Network Link– Illuminates when Ethernet Network is connected
Network Data –Illuminates when Network Data is detected
Battery LED:
Slow flash Green – Battery has good/acceptable voltage
Slow flash Yellow – Battery has low voltage
Slow flash Red – Battery has unacceptable voltage
ON – 0.2 seconds
OFF – 0.8 seconds
Status LED:
Fast flash Red – Flash Card Error
No light - Waiting for Trigger
Solid RED – Triggered and Recording – clock not set via GPS
Solid Green - Triggered and Recording – clock set via GPS
1.2 DAQlink III Software Installation and Setup
Insert the Vscope CD in your computer. The CD will automatically install the Vscope program
and DAQlink III manual.
• Vscope.exe – Program used to acquire analyze and store the analog data.
• DAQlink III manual
1.3 Ethernet Setup
The Ethernet must be setup before using the DAQlink III system
Please refer to Ethernet setup section of the manual for detailed instructions on setting up the
Ethernet settings on your computer.
To Next Page
Loading...