98 User’s Manual
6.1.5 Continuous Recording Examples
Example 1: Setup DAQlink III for Autonomous continuous recording using GPS time.
With the following setup the DAQlink III will record the data to the internal Flash
memory. The data must be downloaded to the Vscope computer after recording is completed.
Each record will have 60 seconds. There will be a NO delay between records.
Sample Rate = 1.00 msec
Sample Length = 60 seconds
Standalone Mode enabled – this selection disables the output to the Vscope computer.
Trigger on PPS pulse
Start Time 00:00:00
Repeat Every 00:10:00
Synchronize A-D
Auto Start – Without Start command
To Next Page
Loading...