95
6.1.2 DAQlink III Auto Start Feature
The DAQlink III also has an auto start feature. This feature is enabled in the Options-
Device-DAQ setting menu. Advance Mode must be selected in the Option-Preference menu to
enable this screen. There are three selections in this menu
1. Disabled – This selection disables the DAQlink III auto start
2. Without Start Command – When this selection is enabled, the DAQlink III will
start acquisition as soon as the unit is powered up. This selection is used when
the DAQlink III will not be connected to a computer running Vscope during
acquisition.
3. After Start Command – This selection enables the auto start feature after a
“Start” Command has been sent from the Vscope program. This mode is used
when the unit is connected to a computer running Vscope.
To Next Page
Loading...