31
Trigger Settings allows for two different trigger inputs
1. Auto Trigger (ReMi) - When this selection is enabled, the DAQlink unit will
trigger immediately and will record and transmit data to the Vscope program
without an external trigger
2. Trigger on Time Break (Hammer Switch) – When this selection is enabled, the
DAQlink unit waits for a switch closure on the trigger input connector. This
selection is used when trigger input is connected to a standard Hammer switch.
Pins A and C of the 3-pin connector must be connected to the “+” side of the
Hammer switch, and Pin B must be connected to the “–“side of the Hammer
switch.
To Next Page
Loading...