6.14
SEL-551 Relay Instruction Manual Date Code 20110408
Front-Panel Interface
Rotating Default Display
In the preceding example, only two display points (DP2 and DP4) and their
corresponding display point labels are set. If additional display points and
corresponding display point labels are set, the additional enabled display point
labels join the
two seconds per screen rotation on the front-panel display.
Display point label settings are set with the SET T command or viewed with
the SHOWSET T command via the serial port [see Section 4: Setting the
Relay and SHO Command (Showset) on page 5.16].
To Next Page
Loading...
