SEON TH8 - Basic DVR Configuration

© 2019 Safe Fleet | All rights reserved | Part #: 700-1123 R4
p. 34
TH8 Installation and Conguration Guide

Basic DVR Conguration
The DVR menu defaults cover most operational settings, but some basic customer and region-specic settings
need to be congured for the DVR to operate optimally:
Menu Names Required Settings
For more
information:
Time and Date,
DST Settings
Select display formats.
Enter the current time and date, including Daylight Saving if
applicable.
Select the Time Zone.
If GPS is installed, set GPS Time Sync ON to detect time and
vehicle location.
see page 37
Titles/Display Enter the vehicle number in Main Title, and choose the
information that displays as text when video appears.
see page 39
Title/Display  Monitor Settings If a Rear Vision Camera is installed, select monitor output
settings.
see page 73
Record Set the Record Delay Off to 15-20 minutes for post trip check.
If Wi-Fi is used, set the Power Delay Off to 2 hours for archive
download.
If IP cameras or RTSP video sources such as a companion
DVR (for example, a TH4C) are connected, congure the HD
Cam Expansion ports.
see page 52
Record  Camera Congure cameras. Turn off any unused camera channels, to
avoid VLOSS events.
see page 42
Alarms and Signals  Alarms Congure each alarm depending on source (Signals, Speed, G
Sensor, GPS Fence, Wake).
see page 49
Alarms and Signals  Signals Congure which signals will trigger alarms. Excessive speed
and G Sensor readings can be set as signal outputs.
see page 47
Alarms and Signals  Speed If the DVR is used in Canadian eets, select KPH speed units. see page 64
Alarms and Signals  G Sensor If a G Sensor is installed, Calibrate. see page 61
Network If Wi-Fi network is used, set addresses as instructed by a
network administrator.
see page 55
System Select the audio channel to output from the DVR audio RCA
socket.
If a Diagnostic Indicator or RGY Illuminator is installed, select
it here.
see page 69
System  Program Update Upload DVR conguration if necessary.
Format the hard drive after all settings have been made.
see page 71